This project is based on dual axis Solar Tracking system with parabolic reflector.
- utilize 96% of solar radiation
-Increases 36% of efficiency as compare to other solar tracker
-Low cost
-360x360 degree angle coverage
-Auto solar detector.
Hardwares:-
-2 DC motor
-LCD
-PIC Micro controller
- L298
-Relay
-Solar panel
-Windmill
-Parabolic reflector.
Description:-
-Can you seen any flat type solar tracking system?.
-On that flat type solar tracker when solar radiation are present in 90 degree angle than it will generate high amount of energy.
-But our earth is movable per 4 minutes it changes 1 degree so when solar radiation angle change than it generates low energy.
-So to avoid this problem i am used parabolic reflector.
-On reflector focal point i install 1 solar panel and generate energy.
-To increase more efficiency i am install number of solar panel on parabolic surface and generated high amount of energy.
-To change angle and tracker sun i am use 2 DC motor which operate on LDR (Light Dependant Resistor).
-I am used 4 LDR on 4 side and program than on which LDR high amount of solar radiation are present motors will turn solar panel on that direction.
-Generated energy i am store it in to battery for other application by using relay because At rains season solar panel generate low amount of energy to maintain efficiency i am also used windmill to generate energy from wind, Both of this energy i am store it in battery.
-On LCD i am shows all the status of LDR and battery.
-On LCD i am shows all the status of LDR and battery.
Please comment and give
Suggestion on this post, if you want any other program or help then type in
comment or contact me, and give feedback for this blogs.
No comments:
Post a Comment